Volume 8, Issue 1, January 2019, Page: 33-41
Design and Control of Single-Phase-to-Three-Phase PFC for Cereals Grinding System Fed by PV-Battery Microgrid
Moustapha Diop, Renewable Energy Laboratory, Polytechnic Higher School, Cheikh Anta Diop University, Dakar, Senegal
Mouhamadou Thiam, Laboratory of Science and Technology of Water and Environment, Polytechnic School of Thiès, Thiès, Senegal
Alphousseyni Ndiaye, Renewable Energy Laboratory, Polytechnic Higher School, Cheikh Anta Diop University, Dakar, Senegal; Research Team of Energetic System and Efficiency, Alioune Diop University of Bambey, Bambey, Senegal
Samba Gueye, Renewable Energy Laboratory, Polytechnic Higher School, Cheikh Anta Diop University, Dakar, Senegal
Lamine Thiaw, Renewable Energy Laboratory, Polytechnic Higher School, Cheikh Anta Diop University, Dakar, Senegal
Received: Dec. 31, 2018;       Accepted: Jan. 28, 2019;       Published: Mar. 15, 2019
DOI: 10.11648/j.epes.20190801.14      View  344      Downloads  78
PV/Battery microgrids hold the most promising solution for providing electricity to remote areas. However, the power quality of these microgrids is vulnerable to nonlinear loads and power electronics components, often necessary to power certain systems such as the cereal grinding systems. These grinding systems consist of mills locally designed driven by induction motors. Given the constraints of microgrids and the structure of the cereal grinding system, a single-phase-to-three-phase Power Factor Corrector with two control strategies is proposed. The PFC control is used to control the power quality of the microgrid but also to regulate the DC-link voltage. The field oriented control strategy is used to improve the system efficiency. The performance of the power converter and control strategies are evaluated in simulation under Simulink environment. Results have verified the effectiveness of the proposed controls with a low current Total Harmonic Distortion, a near-unity power-factor and a significant efficiency improvement of cereals grinding system.
Cereals Grinding System, Microgrid, Single-Phase-to-Three-Phase Converter, Power Factor Corrector
To cite this article
Moustapha Diop, Mouhamadou Thiam, Alphousseyni Ndiaye, Samba Gueye, Lamine Thiaw, Design and Control of Single-Phase-to-Three-Phase PFC for Cereals Grinding System Fed by PV-Battery Microgrid, American Journal of Electrical Power and Energy Systems. Vol. 8, No. 1, 2019, pp. 33-41. doi: 10.11648/j.epes.20190801.14
Copyright © 2019 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
L. Thiaw, G. Sow, and S. Fall, “Application of Neural Networks Technique in Renewable Energy Systems,” 2014 First Int. Conf. Syst. Informatics, Model. Simul. Appl., pp. 6–12, 2014 [Online]. Available: http://dx.doi.org/10.1109/SIMS.2014.12.
D. R. Thiam, “Renewable decentralized in developing countries: Appraisal from microgrids project in Senegal,” Renew. Energy, vol. 35, no. 8, pp. 1615–1623, 2010 [Online]. Available: http://dx.doi.org/10.1016/j.renene.2010.01.015.
T. Kobayakawa and T. C. Kandpal, “Photovoltaic micro-grid in a remote village in India: Survey based identification of socio-economic and other characteristics affecting connectivity with micro-grid,” Energy Sustain. Dev., vol. 18, no. 1, pp. 28–35, 2014 [Online]. Available: http://dx.doi.org/10.1016/j.esd.2013.11.002.
B. K. Das, N. Hoque, S. Mandal, T. K. Pal, and M. A. Raihan, “A techno-economic feasibility of a stand-alone hybrid power generation for remote area application in Bangladesh,” Energy, vol. 134, pp. 775–788, 2017 [Online]. Available: http://dx.doi.org/10.1016/j.energy.2017.06.024.
T. Kobayakawa and T. C. Kandpal, “Analysis of electricity consumption under a photovoltaic micro-grid system in India,” Sol. Energy, vol. 116, pp. 177–183, 2015 [Online]. Available: http://dx.doi.org/10.1016/j.solener.2015.04.001.
T. Kobayakawa and T. C. Kandpal, “Optimal resource integration in a decentralized renewable energy system: Assessment of the existing system and simulation for its expansion,” Energy Sustain. Dev., vol. 34, pp. 20–29, 2016 [Online]. Available: http://dx.doi.org/10.1016/j.esd.2016.06.006.
H. Camblong et al., “Micro-grids project, Part 1: Analysis of rural electrification with high content of renewable energy sources in Senegal,” Renew. Energy, vol. 34, no. 10, pp. 2141–2150, 2009 [Online]. Available: http://dx.doi.org/10.1016/j.renene.2009.01.015.
M. Ikeda and T. Hiyama, “Simulation studies of the transients of squirrel-cage induction motors,” IEEE Trans. Energy Convers., vol. 22, no. 2, pp. 233–239, 2007 [Online]. Available: http://dx.doi.org/10.1109/TEC.2006.874203.
W. L. Silva, A. M. N. Lima, and A. Oliveira, “A method for measuring torque of squirrel-cage induction motors without any mechanical sensor,” IEEE Trans. Instrum. Meas., vol. 64, no. 5, pp. 1223–1231, May 2015 [Online]. Available: https://doi.org/10.1109/TIM.2014.2371192. [Accessed: 07-Dec-2018].
S. Padmanaban et al., “Wavelet-fuzzy speed indirect field oriented controller for three-phase AC motor drive – Investigation and implementation,” Eng. Sci. Technol. an Int. J., vol. 19, no. 3, pp. 1099–1107, 2016 [Online]. Available: http://dx.doi.org/10.1016/j.jestch.2015.11.007.
S. Whaite, B. Grainger, and A. Kwasinski, “Power quality in DC power distribution systems and microgrids,” Energies, vol. 8, no. 5, pp. 4378–4399, 2015 [Online]. Available: http://dx.doi.org/http://dx.doi.org/.
M. H. Amrollahi and S. M. T. Bathaee, “Techno-economic optimization of hybrid photovoltaic/wind generation together with energy storage system in a stand-alone micro-grid subjected to demand response,” Appl. Energy, vol. 202, pp. 66–77, 2017 [Online]. Available: http://dx.doi.org/10.1016/j.apenergy.2017.05.116.
A. Maleki and A. Askarzadeh, “Comparative study of artificial intelligence techniques for sizing of a hydrogen-based stand-alone photovoltaic / wind hybrid system,” Int. J. Hydrogen Energy, vol. 39, no. 19, pp. 9973–9984, 2014 [Online]. Available: http://dx.doi.org/10.1016/j.ijhydene.2014.04.147.
A. Ghafoor and A. Munir, “Design and economics analysis of an off-grid PV system for household electrification,” Renew. Sustain. Energy Rev., vol. 42, pp. 496–502, 2015 [Online]. Available: http://dx.doi.org/10.1016/j.rser.2014.10.012.
Y. Bakelli, A. Hadj Arab, and B. Azoui, “Optimal sizing of photovoltaic pumping system with water tank storage using LPSP concept,” Sol. Energy, vol. 85, no. 2, pp. 288–294, 2011 [Online]. Available: http://dx.doi.org/10.1016/j.solener.2010.11.023.
M. Zaibi, “Smart power management of a hybrid photovoltaic / wind stand-alone system coupling battery storage and hydraulic network,” vol. 146, pp. 210–228, 2018 [Online]. Available: http://dx.doi.org/10.1016/j.matcom.2016.08.009.
F. Mehazzem, A. L. Nemmour, and A. Reama, “Real time implementation of backstepping-multiscalar control to induction motor fed by voltage source inverter,” Int. J. Hydrogen Energy, vol. 42, no. 28, pp. 17965–17975, 2017 [Online]. Available: http://dx.doi.org/10.1016/j.ijhydene.2017.05.035.
Z. Kandoussi, Z. Boulghasoul, A. Elbacha, and A. Tajer, “Sensorless control of induction motor drives using an improved MRAS observer,” J. Electr. Eng. Technol., vol. 12, no. 4, pp. 1456–1470, 2017 [Online]. Available: http://doi.org/10.5370/JEET.2017.12.4.14561456.
Z. M. S. El-Barbary, “Single-to-three phase induction motor sensorless drive system,” Alexandria Eng. J., vol. 51, no. 2, pp. 77–83, 2012 [Online]. Available: http://dx.doi.org/10.1016/j.aej.2012.05.003.
M. Diop, W. Khiari, L. Thiaw, M. Turki, and J. Belhadj, “Characterization and control of a craft mill driven by induction motor fed by photovoltaic mini-grid,” Proc. Int. Conf. Recent Adv. Electr. Syst. Tunis., pp. 119–124, 2016 [Online]. Available: http://journal.esrgroups.org/jes/icraes/IcraesProceedings.html.
T. Ma, H. Yang, L. Lu, and J. Peng, “Optimal design of an autonomous solar-wind-pumped storage power supply system,” Appl. Energy, vol. 160, pp. 728–736, 2015 [Online]. Available: http://dx.doi.org/10.1016/j.apenergy.2014.11.026.
F. Farhani, A. Zaafouri, and A. Chaari, “Real time induction motor efficiency optimization,” J. Franklin Inst., vol. 354, no. 8, pp. 3289–3304, 2017 [Online]. Available: http://dx.doi.org/10.1016/j.jfranklin.2017.02.012.
A. Ghosh, S. Ganesh Malla, and C. Narayan Bhende, “Small-signal modelling and control of photovoltaic based water pumping system,” ISA Trans., vol. 57, pp. 382–389, 2015 [Online]. Available: http://dx.doi.org/10.1016/j.isatra.2015.01.008.
M. Fateh and R. Abdellatif, “Comparative study of integral and classical backstepping controllers in IFOC of induction motor fed by voltage source inverter,” Int. J. Hydrogen Energy, vol. 42, no. 28, pp. 17953–17964, 2017 [Online]. Available: http://dx.doi.org/10.1016/j.ijhydene.2017.04.292.
Browse journals by subject